Torque Specs
ENGINE ( 1.3ltr )
head bolt...51-54
cylinder head cover bolt...3-3.5
spark plug...14.5-21.5
dist. gear case...6-8.5
rocker arm shaft screw...7-8.5
valve adjusting screw lock nut...11-13.5
crankshaft main bearing cap bolt...36.5-41
oil filter stand...14.5-18
oil filter ass'y...9-11.5
oil drain plug...22-28.5
oil pan bolt and nut...7-8.5
oil pump strainer bolt...7-8.5
water pump bolt and nut...7-8.5
cooling fan nut...6-8.5
flywheel bolt...41.5-47
oil seal housing bolt...7-8.5
connecting rod bearing cap nut...24-26.5
crankshaft pulley bolt...7-9
crankshaft timing belt pulley bolt...76-83
timing belt cover bolt and nut...7-8.5
camshaft timing pully bolt...41-46
timing belt tensioner bolt...17.5-21.5
timing belt tensioner stud...7-8.5
oil pump case bolt...7-8.5
oil pump rotor plate screw...7-8.5
inlet and exaust manifld nut...13.5-20
engine monting bracket frame side bolt...29-43
engine mounting braket engine side bolt...36.5-43
engine mounting nut...29-36
transmission mountingbracket bolt...13.5-20
transmission mounting bolt...13.5-20
transmission mounting and frame bolt...13.5-20
propeller shaft flange bolt and nut...36.5-43
 

FUEL SYSTEM

fuel filter union bolt...22-28.5
blind plug of fuel filter union bolt...7-7.5
flare nut of fuel pipe...22-28.5
 

EFI

throttle body mounting bolt...13.5-20
fuel inletpipe bolt of throttle body...6-8.5
throttle upper and lower body screw...2.5
fuel pressure regulator screw...2.5
injector cover screw...1.4
TPS bolt...2.5
ATS...7.5-14
WTS...9.5-12.5
REGTS...7.5-14
O2 Sensor...33-39.5
Valve lash is the gap that exists between the rocker arm adjusting screw and the butt-end of the valve stem. Valve lash should be checked (and adjusted, if necessary) in Samurais every 15,000 miles (24,000 km) or 12 months--whichever comes first--using the procedure below. Use a quality thickness gauge set to make your measurements. Proper clearances are as follows:
  Cold Engine
Coolant temperature
59°-77°F (15°-25°C)
Warm Engine
Coolant temperature
140°-154°F (60°-68°C)
Intake 0.13-0.17mm
0.0051-0.0067"
0.23-0.27mm
0.009-0.011"
Exhaust 0.16-0.20mm
0.0063-0.0079"
0.26-0.30mm
0.0102-0.0118"